Procedure
Step 1 Connect signal cables to corresponding signal connectors.
● Ensure that the protection layer of the cable is in the connector. The surplus
core should be cut
o from the protection layer.
● Ensure that the exposed core is totally inserted into the cable hole.
● Ensure that the signal cables are connected securely.
● Ensure that the cables are not twisted.
● If multiple signal cables need to be connected to a single connector, ensure
that the outer diameters of the signal cables are the same.
Figure 5-25 Crimping two signal cables
Figure 5-26 Crimping three signal cables
Copy-SUN2000-(2KTL-6KTL)-L1
User Manual 5 Electrical Connection
Issue 06 (2022-03-10) Copyright © Huawei Technologies Co., Ltd. 55
To Next Page
Loading...
