Huawei FusionServer Pro 1288H V5 - Page 122

Procedure
Step 1 Congure an IP address for the client (PC) to enable communication between the
client and the iBMC.
The IP address congured and the iBMC management network port IP address
must be on the same network segment.
Step 2 Open the console and set the folder where the IRC is stored as the working folder.
Step 3 Run the chmod 777 KVM.sh command to set the permission for the Independent
Remote Console.
Step 4 Open the Independent Remote Console.
./KVM.sh
The Connect to iBMC dialog box is displayed.
Figure 9-11 Connect to iBMC
Step 5 Enter the network address, user name, and password.
● The network address can be in any of the following formats:
– iBMC management network port IP address (IPv4 or IPv6 address):Port number
Enter an IPv6 address in brackets or an IPv4 address directly, for example,
[2001::64]:444 or 192.168.100.1:444.
– iBMC domain name address:Port number
● When the port number is the default port number 443, the port number can be left
blank.
Step 6 Select a login mode.
● Shared Mode: allows two users to access and manage a server at the same
time. Each user can view the operations performed by the other user.
● Private Mode: allows only one user to access and manage a server at a time.
Step 7 Click Connect.
A security warning is displayed.
FusionServer Pro 1288H V5 Server
User Guide 9 Common Operations
Issue 13 (2020-06-05) Copyright © Huawei Technologies Co., Ltd. 114