● Place the connectors of all service data cables at the bottom of the cabinet so
that the connectors are dicult to reach.
7.2.6.2 Connecting Mouse, Keyboard and VGA Cables
The front and rear panels of the server provide DB15 VGA ports but no standard
PS/2 port for a keyboard or mouse.
You can connect a keyboard and mouse to the USB port on the front or rear panel
based on site installation conditions. There are two connection methods:
● Connect the keyboard and mouse to the USB ports.
● Connect the keyboard and mouse using a USB-to-PS/2 cable.
This section describes how to connect a keyboard and mouse using a USB-to-PS/2
cable and connect a monitor using a VGA cable.
Procedure
Step 1 Connect the USB connector of the USB-to-PS/2 cable to a USB port on the front or
rear panel of the server.
Step 2 Connect the PS/2 connectors of the USB-to-PS/2 cable to the keyboard and
mouse.
Step 3 Connect the DB15 connector of the VGA cable to the VGA port on the front or
rear panel of the server and tighten the two screws.
Step 4 Connect the other connector of the VGA cable to the VGA port on the monitor
and tighten the two screws.
Figure 7-14 Connecting a USB-to-PS/2 cable and VGA cable
----End
7.2.6.3 Connecting Network Cables
Before connecting or replacing a network cable, use a network cable tester to
ensure that the new network cable is functional.
FusionServer Pro 1288H V5 Server
User Guide 7 Installation and Conguration
Issue 13 (2020-06-05) Copyright © Huawei Technologies Co., Ltd. 70
To Next Page
Loading...
