Huawei FusionServer Pro 1288H V5 - Page 23

1 (Optional) 10GE optical
port (LOM port 1)
2 (Optional) 10GE optical
port (LOM port 2)
3 (Optional) 10GE electrical
port (LOM port 1)
4 (Optional) 10GE electrical
port (LOM port 2)
5 VGA port 6 GE electrical port (LOM
GE port 3)
7 GE electrical port (LOM
GE port 4)
8 Management network
port
9 Serial port 10 USB 3.0 ports
11 PSU sockets - -
Port Description
Table 2-4 Ports on the rear panel
Port Type Quantity Description
(Optional)
10GE optical
port
10GE SFP+ 2 10GE LOM service ports
(optical). Use the optical or
electrical ports based on
service requirements.
(Optional)
10GE
electrical port
10GE BASE-T 2 10GE LOM service ports
(electrical). Use the optical or
electrical ports based on
service requirements.
GE electrical
port
1000BASE-T 2 GE LOM service ports
(electrical).
VGA port DB15 1 Used to connect a display
terminal, such as a monitor or
KVM.
Serial port RJ45 1 Default operating system
serial port used for debugging.
You can also set it as the iBMC
serial port by using the iBMC
command.
NOTE
The port uses 3-wire serial
communication interface, and the
default baud rate is 115,200 bit/s.
FusionServer Pro 1288H V5 Server
User Guide 2 Hardware Description
Issue 13 (2020-06-05) Copyright © Huawei Technologies Co., Ltd. 15