Huawei FusionServer Pro 1288H V5 - Page 81

You are advised to arrange cables in the same way as existing cables. Ensure
that cables are routed neatly and undamaged.
● Separate optical cables or SFP+ cables from power cables and signal cables
when laying out the cables.
● The minimum bend radius of an optical cable or SFP+ cables is 4 cm (1.57
in.).
● Ensure that optical cables or SFP+ cables are laid out for easy maintenance
and capacity expansion.
● Optical cables must be bound using cable ties. Ensure that:
– Optical cables are bound closely, neatly, and straight.
– Cable ties are in even distance and fastened properly.
Step 4 Connect the cable to an optical port.
● When you use an optical cable:
a. Remove the optical cable to be replaced.
b. Connect the new optical cable.
▪ Connect the new optical cable to the same port as the removed one.
▪ Connect the optical cable to the optical module securely.
i. Insert the optical module into the optical port. See (1) in Figure
7-16.
ii. Close the latch on the optical module to secure it. See (2) in Figure
7-16.
iii. Insert the optical cable into the optical module. See (3) in Figure
7-16.
FusionServer Pro 1288H V5 Server
User Guide 7 Installation and Conguration
Issue 13 (2020-06-05) Copyright © Huawei Technologies Co., Ltd. 73