Huawei LUNA2000-100KTL-M1 - Page 67

No. Category Parameter Description Remarks
10 Shutdown
gradient
Shutdown
gradient (%/s)
Species the power change
rate when the device shuts
down.
-
11 Hibernate at
night
Hibernate at
night
The device performs the
monitoring function at night.
If this parameter is set to
Enable, the monitoring
function of the device will
hibernate at night to reduce
power consumption.
-
12 Upgrade delay Upgrade delay This parameter is mainly used
in upgrade scenarios where
the power supply at DC side
is disconnected.
After the upgrade
starts, if Upgrade
delay is set to
Enable, the upgrade
package is loaded
rst. After the DC
side power supply
recovers and the
activation conditions
are met, the device
automatically
activates the
upgrade.
13 HVRT/LVRT HVRT HVRT is short for high
voltage ride-through. When
the grid voltage is abnormally
high for a short time, the
device cannot disconnect
from the power grid
immediately and must
continue to operate for some
time.
-
14 HVRT triggering
threshold (V)
Species the threshold for
triggering HVRT. The
threshold settings should
meet the local grid standard.
This parameter is
displayed when
HVRT is set to
Enable.
LUNA2000-100KTL-M1 Smart Power Control System
User Manual 6 Power-On Commissioning
Issue 02 (2023-01-10) Copyright © Huawei Technologies Co., Ltd. 61