4.3 Pre-installation Checks
Checking the Outer Packing
Before unpacking the device, check the outer packing for damage, such as holes
and cracks, and check the device model. If any damage is found, or if the device
model is not what you requested, do not unpack the product and contact your
dealer as soon as possible.
You are advised to install the device within 24 hours of removing the outer packing.
Unpacking the Device
Step 1 Use diagonal pliers to cut the packing tape, and use a utility knife to slice the tape
along the gaps in the packaging. Take care not to damage the device inside.
Step 2 Open the packaging and check the deliverables.
----End
Checking Deliverables
After unpacking the device, check that the deliverables are intact and complete,
and check that the device is free from any obvious damage. If any items are
missing or damaged, contact your dealer.
For details about the number of accessories delivered with the device, see the
Packing List
included in the packaging.
4.4 Moving the Smart PCS
If the installation position is too high to install the Smart PCS directly on the
mounting bracket, run a rope (strong enough to bear the weight of the Smart
PCS) through the two lifting eyes, and use it to hoist the Smart PCS.
Ensure that the lifting handles are installed to the correct screw holes. Do not
install them to the mounting bracket screw holes on the top. Incorrect installation
may cause device damage or personal injury.
LUNA2000-200KTL-H0 Smart Power Control System
User Manual 4 Installation
Issue 05 (2022-06-30) Copyright © Huawei Technologies Co., Ltd. 21
To Next Page
Loading...