Huawei LUNA2000-200KTL-H0 - Connecting DC & AC Power Cables

Figure 5-7 Replacing the crimping module (on the AC side)
----End
Follow-up Procedure
Use scissors to cut
o the joints of the rubber rings in order to remove them.
Remove all rubber rings in the same way.
NO TE
Remove the rubber rings according to the cable diameter range, and ensure that the
crimping module is not damaged. Otherwise, the device may fail to oer the expected level
of protection.
Figure 5-8 Removing the rubber ring
5.6 Connecting DC Power Cables
Precautions
Before connecting the DC power cables, check the following items:
● Check that the DC switches between the DC side of the Smart PCS and the DC
LV Panel busbar are in the OFF position.
● Check the polarities of the cables and label them properly.
LUNA2000-200KTL-H0 Smart Power Control System
User Manual 5 Electrical Connections
Issue 05 (2022-06-30) Copyright © Huawei Technologies Co., Ltd. 35