4.6 Wall-Mounted Installation
Prerequisites
● You have prepared expansion bolts. M12x60 stainless steel expansion bolts are
recommended.
● Purchase the mounting bracket separately from the Company.
Installation Procedure
Step 1 Install the mounting bracket.
Avoid drilling holes into the water pipes or power cables buried in the wall.
● To avoid inhaling dust and to prevent dust from falling into your eyes, ensure
that safety goggles and a dust mask are worn when drilling holes.
● Wipe away any dust in or around the holes and measure the spacing. If the
holes are inaccurately positioned, drill the holes again.
● Level the top of the expansion sleeve with the concrete wall after removing the
bolt, spring washer, and
at washer. Otherwise, the mounting bracket will not
be securely installed on the concrete wall.
Figure 4-13 Installing the mounting bracket
LUNA2000-200KTL-H0 Smart Power Control System
User Manual 4 Installation
Issue 05 (2022-06-30) Copyright © Huawei Technologies Co., Ltd. 26
To Next Page
Loading...