Huawei OptiX OSN 6800 - 4 Checking the Battery Jumper on the SCC

11
Make sure that the jumper settings are set as shown in the following figure prior to using an SCC
board. When a battery is required, place a jumper cap over pin 3 and pin 2. When the power
supplied by the battery is not required, place a jumper cap over pin 2 and pin 1.
4 Checking the Battery Jumper on the SCC
CAUTION
TN11SCC
CPU
Battery Jumper
CF
Card
Battery Jumper
J11
J11
J11
Battery is
used
Battery is
not used