Insert the guide strip on the lower side
(without an arrow) of the blank filler
panel to the sliding guide of a vacant
slot, and make sure that the ejector
level is locked to the occlusal notch of
the subrack.
6
2
1
Wear an ESD strap whenever coming into contact with a metal component of the equipment.
2
1
Remove the blank
filler panel.
Insert the board.
Push the ejector
levers inwards.
Hold the ejector
levers outwards.
Remove the
board.
Inserting a board
Removing a board
4
3
1
2
2 Installing Boards
NOTE
1
2
4
3
Pinch the upper
side (the side with
an arrow) of the
blank filler panel.
Push the upper side (the side
with an arrow) of the blank filler
panel to the subrack. The blank
filler panel is properly installed if
a snap is heard.
CAUTION
1. Before installing a board, verify that board connectors have no scratches,
holes, or damage, the backplane has no bent pins, and the plastic cover of the
48 V power connector is not detached. If an abnormality is found, contact
Huawei engineers for help.
2. Handle boards gently to avoid damage to board connectors.
To Next Page
Loading...
