14
6 Setting the Jumpers on the ROP
There are two groups of jumpers on the ROP boards. The two groups are identified as J3 and J4.
Jumpers 9 to 10 in J3 and 1 to 6 in J4 are used for internal identification on the board.
To ensure the normal operation of the board, follow the requirements below to set the jumpers.
•Never cap jumpers 1 to 2 in group J3.
•Never cap jumpers 3 to 4 in group J3.
•Never cap jumpers 5 to 6 in group J3.
•Never cap jumpers 7 to 8 in group J3.
•Never cap jumpers 9 to 10 in group J3 (in non-extended slot numbering mode).
•Always cap jumpers 9 to 10 in group J3 (in extended slot numbering mode).
•Always cap jumpers 1 to 2 in group J4.
•Always cap jumpers 3 to 4 in group J4.
•Never cap jumpers 5 to 6 in group J4.
Jumpers 7-8 and 9-10 in group J4 are used to specify the logical slot for the ROP board.
When setting jumpers 7-8 and 9-10 in group J4 in non-extended slot numbering mode, follow the instructions below:
•When jumpers 7-8 and 9-10 in group J4 are not capped, the logical slot for the ROP board is IU28.
•When jumpers 7-8 in group J4 are capped and jumpers 9-10 are not capped, the logical slot for the ROP board is IU29.
•When jumpers 7-8 in group J4 are not capped and jumpers 9-10 are capped, the logical slot for the ROP board is IU30.
•When jumpers 7-8 and 9-10 in group J4 are capped, the logical slot for the ROP board is IU31.
When setting jumpers 7-8 and 9-10 in group J4 in the extended slot numbering mode, follow the instructions below:
•When jumpers 7-8 and 9-10 in group J4 are not capped, the logical slot for the ROP board is IU124.
•When jumpers 7-8 in group J4 are capped and jumpers 9-10 are not capped, the logical slot for the ROP board is IU125.
•When jumpers 7-8 in group J4 are not capped and jumpers 9-10 are capped, the logical slot for the ROP board is IU126.
•When jumpers 7-8 and 9-10 in group J4 are capped, the logical slot for the ROP board is IU127.
NOTE
1
2
9
10
10
1
2
9
J4 J3
CPU
J3J4
ROP
To Next Page
Loading...
