Huawei PDU8000 Series - Installing the PDC; Moving the PDC

PDU8000 Modular Precision PDC V2.0
User Manual
5 Installation Guide
Issue 03 (2018-01-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34

This table may not list some tools required at specific sites. Site installation personnel and technical
support personnel should prepare tools based on site requirements.

Prepare firestop putty for sealing cable holes after cable connection. Huawei does not provide the
firestop putty. The customer needs to purchase it.
5.2.3 Checking Personnel Requirements
Construction personnel must have basic knowledge of safe operation, be trained to master
correct operation methods, and have the appropriate job qualifications.
The owner should pay attention to the following items when organizing the construction
personnel to carry out construction work:

Construction personnel have been trained and qualified by Huawei to master methods for
system installation and commissioning, and have obtained work permits before they
begin to install and commission equipment.

The number of construction personnel depends on the project progress and the
installation environment.

Construction personnel have read through the safety precautions and related product
documents before they begin work.
5.3 Installing the PDC
Prerequisites

The installation environment has been checked with expected results.

The site has been closed off, and notices have been posted.

The PDC has been unpacked and inspected, and no problems were found.

You have obtained the tools and meters required for the installation.

Installation personnel must be qualified and certified. Power distribution equipment
operators must hold a primary electrician certificate or higher.
Context

A modular precision PDC can be installed on a concrete floor or an ESD floor.

A modular precision PDC can be deployed separately or combined with another cabinet.
As the onsite conditions may vary, the following steps are for reference only. Onsite installation
personnel and technical engineers can decide whether to perform the steps based on the actual situation.
5.3.1 Moving the PDC
Context