PowerCube 5000
User Manual (SmartLi 100Ah)
Copyright © Huawei Technologies Co., Ltd.
Step 6 Gently push the SMU02S along guide rails until it is engaged. Close the handle, and push the
locking latch rightwards.
Figure 9-9 Installing the SMU02S
Step 7 Reconnect the communications cable to the SMU02S panel.
Step 8 Reset SMU02S parameters.
----End
Follow-up Procedure
Pack the removed component and have it sent to the local Huawei warehouse.
9.1.5.2 Replacing a UIM02C
Prerequisites
An ESD wrist strap, ESD gloves, ESD box or bag, cabinet door key, and required tools
are available.
The new UIM02C board is intact.
Procedure
Step 1 Connect the ground cable to the ESD wrist strap, and put on the ESD wrist strap and ESD
gloves.
Step 2 Record the position of signal cables connected to the UIM02C panel, and then disconnect the
signal cables.
Step 3 Unscrew and take out the UIM02C.
To Next Page
Loading...
