Huawei PowerCube 5000 - Frequently Asked Questions (FAQ); Installing an Expansion Sleeve

PowerCube 5000
User Manual (SmartLi 100Ah)
10 FAQ
Issue 02 (2020-03-17)
Copyright © Huawei Technologies Co., Ltd.
144
10 FAQ
10.1 How Do I Install an Expansion Sleeve
Step 1 Drill a hole into the concrete floor using a hammer drill. The hole depth should range from 52
mm to 60 mm.
Step 2 Slightly tighten the expansion bolt and vertically insert it into the hole. Knock the expansion
bolt using a rubber mallet until the expansion sleeve is fully inserted into the hole.
Step 3 Partially tighten the expansion bolt.
Step 4 Remove the expansion bolt, spring washer, and flat washer.
Figure 10-1 Drilling a hole and installing an expansion sleeve
(1) M12 bolt
(2) Spring washer
(3) Flat washer
(4) Expansion sleeve
(5) Expansion nut
(6) Concrete floor
----End