PowerCube 5000
User Manual (SmartLi 100Ah)
Copyright © Huawei Technologies Co., Ltd.
Figure 9-19 Removing screws
Step 4 Hold the MDU front panel by one hand, and push out the MDU from the fastener on the front
panel by the other hand.
Figure 9-20 Removing the MDU
Step 5 Install the new MDU and tighten screws.
Step 6 Reconnect the cables to the new MDU based on the recorded information.
Step 7 Disconnect the ground cable of the ESD wrist strap, and remove the ESD wrist strap and ESD
gloves.
----End
Follow-up Procedure
Pack the removed component and send it to the local Huawei warehouse.
To Next Page
Loading...
