Huawei PowerCube 5000 - ICC Cabinet Components: Bypass Module (BPS)

PowerCube 5000
User Manual (SmartLi 100Ah)
2 Products
Issue 02 (2020-03-17)
Copyright © Huawei Technologies Co., Ltd.
20
Figure 2-9 Appearance
(1) Positioning lock
(2) Ready switch
(3) Indicators
(4) Battery cold start button

The power supply can be manually connected only if the battery cold start button is held down for 5s
at least.

A short circuit in the BPS power supply to loads may cause a DG output short circuit.
Table 2-3 Indicator description
Indicator
Color
Status
Description
Power indicator
Green
Steady on
The system is working in bypass
mode.
Blinking
slowly
The bypass has no output (blinking at
0.2 Hz, on for 2.5s and off for 2.5s).
Blinking
fast
The bypass is not configured or the
DSP software is being upgraded
(blinking at 4 Hz, on for 0.125s and
off for 0.125s).
Off
The bypass CPLD software is being
upgraded.
Alarm indicator
Yellow
Steady on
A minor alarm is generated for the
bypass.
Off
There is no minor alarm for the
bypass, or the CPLD software is being
upgraded.
Fault indicator
Red
Steady on
A critical alarm is generated for the
bypass.
Off
There is no critical alarm for the
bypass, or the CPLD software is being
upgraded.