Huawei Technologies Proprietary
5-3
2) Set the serial interface parameters. As shown in Figure 5-4, in the properties
dialog box of the serial interface, set the baud rate to 9600, data bit to 8, no parity
check, stop bit to 1, and flow control to none. Then, click <OK> to return to the
HyperTerminal window.
Figure 5-4 Setting serial interface parameters
3) Set HyperTerminal properties. Select [File\Properties\Settings] in the
HyperTerminal to enter the properties setting window as shown in
Figure 5-5.
Select the terminal emulation type to be VT100 or Auto detect, and click <OK> to
return to the HyperTerminal window.
To Next Page
Loading...
