Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Disconnect stack cables to remove the member switches.
In a stack with a ring topology, connect the two stack interfaces that connect the removed
member switch using stack cables to ensure network reliability. Connect stack port 0/1 of
the member switch to stack port 0/2 of the neighboring member switch. Otherwise, the
stack may fail to run properly.
In a stack with a chain topology, removing an intermediate device may cause the split of
the stack. Therefore, analyze services before removing member switches from the stack
to minimize the impact on services.
Step 3 Add the removed member switches as standalone devices to the network again.
A removed device was a member switch, so it uses the stack MAC address within the stack
MAC address switching delay to inherit the configuration of the member switch. After the
stack MAC address switching delay expires, the removed device uses its own system MAC
address.
----End
To Next Page
Loading...
Need help?
General