Huawei SUN2000-4KTL-L1 User Manual

Type Tools and Instruments
Marker Steel measuring tape Level
Hydraulic pliers Heat-shrink tubing Heat gun
Personal protective
equipment (PPE)
Insulated gloves Protective gloves
Dust mask
Safety boots
Safety goggles
-
4.3 Determining the Installation Position
Basic Requirements
● The SUN2000 is protected to IP65 and can be installed indoors or outdoors.
● Do not install the SUN2000 in a place where personnel are easy to come into
contact with its enclosure and heat sink, because these parts are extremely
hot during operation.
● Do not install the SUN2000 near
ammable or explosive materials.
● Do not install the SUN2000 at a place within children's reach.
● The SUN2000 will be corroded in salt areas, and the salt corrosion may cause
re. Do not install the SUN2000 outdoors in salt areas. A salt area refers to
the region within 500 meters from the coast or prone to sea breeze. The
SUN2000-(2KTL-6KTL)-L1
User Manual 4 System Installation
Issue 10 (2023-02-13) Copyright © Huawei Technologies Co., Ltd. 26

Huawei SUN2000-4KTL-L1 Specifications

General

Max. efficiency	98.4%
Max. input voltage	600 V
Rated output power	4000 W
Dimensions (W x H x D)	365 x 365 x 156 mm
Max. apparent AC power	4000 VA
Nominal AC voltage	220 V / 230 V / 240 V
MPPT voltage range	200-1000 V
Number of MPP trackers	2
Max. short-circuit current per MPPT	15 A
Operating temperature range	-25°C to +60°C
Protection degree	IP65
Max. Input Power	6000 W
Max. Output Power	4000 W
Rated Output Voltage	220 V / 230 V / 240 V
Output Frequency	50 Hz / 60 Hz
Cooling Method	Natural convection
AC voltage range	180 V to 280 V