You are advised to apply anti-rust paint on the hole positions for protection.
----End
4.5.2 Wall-mounted Installation
Prerequisites
To install the SUN2000, you need to prepare expansion bolts. M12x60 stainless
steel expansion bolts are recommended.
Procedure
Step 1 Determine the positions for drilling holes and mark the positions using a marker.
Step 2 Secure the mounting bracket.
Avoid drilling holes in the water pipes and cables buried in the wall.
Figure 4-12 Expansion bolt composition
(1) Bolt
(2) Nut (3) Spring washer
(4) Flat washer (5) Expansion sleeve
● To prevent dust inhalation or contact with eyes, wear safety goggles and an
anti-dust mask when drilling holes.
● Clean up any dust in and around the holes using a vacuum cleaner and
measure the distance between holes. If the holes are inaccurately positioned,
drill holes again.
● Level the front of the expansion sleeve with the concrete wall after removing
the bolt, spring washer, and
at washer. Otherwise, the mounting bracket will
not be securely installed on the concrete wall.
SUN2000-(50KTL-ZHM3, 50KTL-M3)
User Manual 4 Installation
Issue 05 (2023-02-28) Copyright © Huawei Technologies Co., Ltd. 30
To Next Page
Loading...
