● The screenshots in this document correspond to the SUN2000 app 6.22.10.117
(Android) and FusionSolar app 6.22.10.117 (Android). The screenshots are for
reference only. The actual screens may vary.
● When the WLAN connection is used, scan the QR code of the WLAN module to
access the login screen.
● When the WLAN connection is used, the initial name of the WLAN hotspot is
Adapter-WLAN module SN, and the initial password is Changeme. Use the initial
password upon
rst power-on and change it immediately after login. To ensure
account security, change the password periodically and keep the new password in
mind. Not changing the initial password may cause password disclosure. A
password left unchanged for a long period of time may be stolen or cracked. If a
password is lost, devices cannot be accessed. In these cases, the user is liable for
any loss caused to the PV plant.
● When the Bluetooth connection is used, the connected Bluetooth device is named
after last 8 digits of the SN barcode+HWAPP.
● After you select Use by default for this USB accessory, a message that asks you
to
conrm the USB access will not appear if you log in to the app again without
removing the USB data cable.
a. (Scenario in which the SUN2000 is connected to the FusionSolar hosting
cloud) Run the FusionSolar app and access the Device Commissioning
screen.
SUN2000-(100KTL, 110KTL, 115KTL)-M2
User Manual 7 Man-Machine Interactions
Issue 02 (2022-06-30) Copyright © Huawei Technologies Co., Ltd. 66
To Next Page
Loading...
Need help?
General
