Servers with Kunpeng 920 5220 or 3210 processors do not support the conguration
of 24 x 2.5-inch SAS/SATA pass-through drives.
Table 2-3 Indicators and buttons on the front panel
Silkscr
een
Indicator/
Button
State Description
Fault
diagnostic
LED
● ---: The server is operating normally.
● Error code: A server component is faulty.
For details about error code, see the
TaiShan Rack
Server iBMC Alarm Handling
.
Power
button/
indicator
Power indicator
● Steady yellow: The server is in the standby state.
● Steady green: The server is properly powered on.
● Blinking yellow: The iBMC is starting.
● O: The server is not connected to a power source.
Power indicator
● When the server is powered on, you can press this
button to shut down the OS.
● When the server is powered on, you can hold down
this button for 6 seconds to force the server to power
o.
● When the server is in the standby state, you can press
this button to start the server.
UID
button/
indicator
The UID button/indicator helps identify and locate a
device.
UID indicator:
● O: The device is not being located.
● Blinking blue (blinking 255 seconds): The device has
been located and is
dierentiated from other devices
that have also been located.
● Steady blue: The device is being located.
UID button:
● You can turn on, turn
o, or blink the UID indicator by
pressing the UID button on the panel or by using the
iBMC CLI or WebUI.
● You can press this button to turn on or
o the UID
indicator.
● You can press and hold down this button for about 5
seconds to reset the iBMC.
TaiShan 200 Server
User Guide (Model 2280) 2 Components
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 13
To Next Page
Loading...
