How to reset the password on a Huawei UPS2000-G-20KRTL UPS?
If you forgot only the LCD password (the preset password is 000001), use the feature code (the preset feature code is 999999) to activate the LCD password. If you forgot both the LCD password and feature code, contact local technical support.
What to do if Huawei UPS has no output voltage?
If the UPS has no output voltage but does not report a fault, check the output power cable connection to ensure it is properly connected.
What to do if Huawei UPS2000-G-20KRTL does not start?
If the UPS does not start after pressing the power button, ensure that you press it for more than 5 seconds until you hear a beep sound.
How to fix a Huawei UPS2000-G-20KRTL UPS when the LCD displays nothing?
If the LCD displays nothing and the system doesn't perform self-tests, first check the UPS input power cable connection to ensure the input power supply is properly connected. Also, use a voltmeter to check whether the UPS input voltage meets the required specifications, as it may be less than the lower threshold or greater than the upper threshold.
Why is the mains indicator off on my Huawei UPS2000-G-20KRTL?
The mains indicator might be off because the mains voltage or frequency exceeds the UPS input range. Use a multimeter to verify that the input voltage and frequency meet the specified requirements.
What to do if the battery indicator blinks on my Huawei UPS2000-G-20KRTL UPS?
If the battery indicator is blinking and the buzzer is buzzing, it indicates that the UPS is about to shut down due to insufficient battery reserve. To prevent data loss or damage, immediately save load data and shut down primary loads. Also, verify that the number of batteries and battery capacity are correctly set based on the actual configuration.
What to do if the AC input indicator is off on my Huawei UPS?
If the AC input indicator is off and the UPS is running on battery despite normal mains, it could be due to the UPS mains switch being OFF. Ensure the UPS mains switch is turned ON. Alternatively, the input cable may not be properly connected; check the UPS input power cable connection.
General safety precautions for installing, operating, and maintaining the equipment.
General safety rules for operating and maintaining the UPS equipment.
Safety measures related to personnel during operations on the equipment.
Specifies the qualifications and training required for personnel handling the UPS.
Safety guidelines related to electrical operations, including grounding and AC/DC power.
Guidelines for safe and proper routing of cables.
Specifies the environmental conditions required for safe UPS installation.
Critical safety precautions for handling and maintaining UPS batteries.
Step-by-step instructions and precautions for installing batteries.
Highlights the dangers and prevention of battery short circuits.
Accesses and displays active, historical, and sorted alarm information.
Provides access to various system configuration settings.
Configuration options for system parameters such as parallel mode and output.
Configuration settings related to batteries, including capacity and charging.
Essential checks to perform before powering on the UPS.
Procedures for starting the UPS in normal and battery modes.
Procedures for shutting down the UPS inverter to bypass or no output state.
Steps required to start the parallel UPS system.
Procedures for shutting down a parallel UPS system.
Emergency Power Off procedure for parallel UPS systems.
General guidelines and schedule for maintaining the UPS.
Procedures and precautions for maintaining UPS batteries.
Compliance with safety regulations and electromagnetic compatibility standards.
Provides a guide to identifying and resolving common UPS alarms and faults.
Steps for performing a battery capacity test on the UPS.
To Next Page
General