Huawei UPS5000-E-300K-SMT - Page 160

UPS5000-E-(50 kVA-300 kVA)
User Manual (50 kVA Power Modules)
4 User Interface
Issue 02 (2017-02-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
151
Item
Description
zero load.
Current
equal.
detection
Monitors the current differences between racks or modules. If this
parameter is set to Enable, the Mod. Cur. Eql. Data can be viewed on
the running information screen. This parameter is set to Disable by
default.
Bus Capa.
Life
If Bus Capa. Life is set to Enable, the UPS detects the bus capacitor
lifespan.
Figure 4-39 Advanced Param. screen 5
Item
Description
Altitude (m)
Set this parameter based on the altitude of the place where the rack is used.
The default value is less than or equal to 1000.
ModbusTCP
Encryption
If Modbus TCP is used for communication, communication links
implement encryption based on the selected encryption mode or do not
implement encryption.
Batt.
charging
capacity
mismatch
This parameter specifies whether the alarm is enabled. An alarm is
generated only when the alarm is enabled and the alarm generating
conditions are met.
Battery
segment
detection
This parameter specifies whether the alarm is enabled. An alarm is
generated only when the alarm is enabled and the alarm generating
conditions are met.
Emergency
Shut Down
Enable
Indicates whether to enable emergency power-off (EPO). EPO is
performed only when this parameter is enabled and the EPO switch is
triggered.