1. Activate the route. To do so, press and hold the Go To button and use the left and right
arrows to browse among available routes. When the route you are looking for is
announced, press Confirm to load the route in the system.
2. You will be asked if you wish to preview the route in Forward direction or in Reverse.
Press Confirm for Forward, or Press and Hold Confirm for Reverse.
3. Press and hold the Left or Right arrow. Trek will announce you are in the Indoor Preview
mode followed by the first instruction.
4. You will be able to navigate through all instructions using the Left and Right arrows
without being interrupted by incoming GPS information.
5. To exit Indoor Preview, press and hold the Left or Right arrow or press Confirm.
9.8.3 Activate a Recorded Route
You can use Trek to guide you along a previously recorded route.
To select a route:
1. Press and hold the Go To button located at the top left corner of the front panel.
2. Use the left and right navigation arrows to browse among available routes.
3. When the route you are looking for is announced, press Confirm to select it.
4. Press Confirm to be guided in forward direction. You will be given instructions on the
direction to take to begin your route. If you wish to travel the route in Reverse, press and
hold the Confirm button.
Along the way, you will be instructed on which direction to take when you come across
intersections. Instructions on street network are given according to hand-side (left/right/go
straight). For example, Trek could tell you to "turn left on Fleet Street."
When you enter an open area, a message will inform you. In this case, clockwise orientation is
used to instruct the user on directions to take. For example, Trek could announce the following
message: "Turn at 10 o'clock. Next instructions in 25 meters."
Upon reaching your destination, a message will be heard and the route will be automatically
deactivated.
For landmarks created by entering an address and for commercial points of interest on maps,
Trek will announce the side of the street of your destination.
Similarly to the Indoor Preview of a Route, at any moment during a guidance session, you can
have the system announce the next or previous instruction by pressing the Right or Left Arrow.
You will be given an instruction indicating a distance and action to be taken.
The Information button will provide route information: On or off route, name of the route, GPS
status, Battery level, City, Pedometer data, Speed and Altitude.
Note: The Online button is temporarily disabled when following a route.
9.8.4 Deviating from Route
If you were supposed to take a turn but continued on the same street for a distance greater than
50 meters, the system will ask you to turn back so that you can return to the intersection.
However, if you find yourself on a street that is not connected to a street on your route, the
system will inform you that you are Off route and will ask you if you want to be rerouted to your
destination. If you press Confirm, the system will provide instructions to guide you to your
destination.
To Next Page
Loading...