Humanware VICTOR READER TREK - Import Routes; Delete All Routes; Configuring Verbosity; Point of Interest Verbosity Settings

Import routes
Selecting this item will import all routes found in both the root and the $TREKRoutes folder of
your SD card.
Delete all routes
Selecting this item will delete all routes saved on your device. If you are sure you wish to delete
all routes, confirm by pressing the # key.
9.15.5 Configuring Verbosity
Use the arrows to select which verbosity option you wish to modify. There are five verbosity
options: Point of interest verbosity, Route information Verbosity, Where am I verbosity,
Intersection verbosity, and Reset verbosity defaults. Press Confirm to select the verbosity option
of your choice.
Point of interest Verbosity settings:
Upon entering the Point of interest Verbosity settings menu, use the arrows to cycle through the
options and press Confirm to make your selection. The Point of interest Verbosity settings are as
follows:
Not announced (default value). Points of interests are not announced and no beep is heard
when encountered.
Tone. Points of interest are only announced by a beep when encountered.
Name and direction. Point of interest are announced with beep and message.
Route instructions Verbosity settings:
Upon entering the Route instructions Verbosity settings menu, use the arrows to cycle through
the options and press Confirm to make your selection. The Route Verbosity settings are as
follows:
Turns only (default value). The next instruction announces only intersection where user
has to turn.
All instructions. The next instruction announces all intersections even if user does not need
to turn.
Where am I verbosity settings:
Upon entering the Where am I Verbosity settings menu, use the arrows to cycle through the
options and press Confirm to make your selection. The Where am I Verbosity settings are as
follows:
Route status and location. Announces Route Status (if a route is activated) and Current
location.
Route status, heading, location, intersection or next instruction (default value) (if a route is
activated).
Route status, heading, location, intersection and next instruction (if a route is activated).
Intersection verbosity settings:
Upon entering the Intersection Verbosity settings menu, use the arrows to cycle through the
options and press Confirm to make your selection. The Intersection Verbosity settings are as
follows:
Crossing streets only. Announces Crossing street.
Detailed. Announces intersection description.
Reset verbosity defaults:
Upon entering the Reset verbosity defaults settings menu, you will be asked confirm that you
want to restore default settings by pressing Confirm.