To leave open area locked, press and hold the Right arrow again. Trek will announce “Leaving
open area locked” and will automatically recognize whether you are in an open area or on a
street.
9.15 Settings
To configure the system, press the 7 button.
Use the arrows to select the option you wish to modify. The list of 10 options is as follows:
GPS
Landmarks
Routes
Import and export
Verbosity
Distance unit
Haptic Feedback
About
Reset Pedometer
Reset GPS position
Press Confirm to select an option.
Press Explore Star or press 7 at any moment to exit the Settings menu.
9.15.1 Turning GPS on
Use the arrows to turn the GPS on or off. Confirm your selection by pressing the Confirm button.
Note that turning the GPS off when you are not using it can preserve your battery life.
9.15.2 Configuring Landmarks
Use the arrows to select the landmark you wish to configure.
Press Confirm to load the selected landmark
Use the arrows to select the operation you wish to perform on the landmark. Operations include:
Rename, Set/Unset as destination and delete.
Press Confirm to trigger the selected operation.
Rename Landmark:
Upon selecting this option, a beep will prompt you to dictate the new name for the landmark in
question. After 4 seconds, recording ends with a beep and message. The system exits
configuration mode and announces the current state.
Set or Unset Landmark as possible destination:
Upon triggering this option, the system will ask you to set or unset the current landmark as a
possible destination. Press Confirm to set or unset the landmark as a destination. Upon doing
so, the system exits configuration mode and announces the current state.
This operation can also be achieved while you are recording your landmark.
When recording the landmark. Press Confirm within 30 seconds after its creation. Trek will
confirm that the landmark has been unset as a possible destination.
Delete Landmark:
Upon selecting this option, the system prompts you to delete the current landmark selected.
Press Confirm to Delete. Upon doing so, the system exits configuration mode and announces
the current state.
To Next Page
Loading...