Humminbird MEGA LIVE 2 - Install the Shaft Mount

9 Trolling Motor Mount
3. Install the Shaft Mount
CAUTION
Disconnect the motor from all sources of electrical power before you start installation.
1. The trolling motor should be in the fully retracted (flat) position on the boat deck
for this installation.
2. Disconnect the motor from all sources of electrical power.
3. Determine if the transducer will be installed on the left or right side of the
trolling motor.
If the trolling motor prop stows on the right (starboard) side of the boat, you
will mount the transducer on the right side of the trolling motor.
If the trolling motor prop stows on the left (port) side of the boat, you will
mount the transducer on the left side of the trolling motor.
Starboard Installation
Port Installation