Humminbird MEGA LIVE 2 - Introduction; Compatibility

1 Introduction
Introduction
This manual will guide you through the following installation requirements for the
MEGA Live 2 transducer:
• Installing the Transducer
• Connecting to the Fish Finder and Power
• Testing the Installation
• Powering O
Before proceeding with this installation, the Humminbird fi sh fi nder
and Minn Kota trolling motor should be installed. The MEGA Live
2 transducer can be connected directly to the fi sh fi nder or to a
Humminbird Ethernet Switch (optional, separate purchase required)
for networking. See the Ethernet Switch installation instructions to
install the Ethernet Switch.
Compatibility
Fish Finders: MEGA Live 2 is compatible with all XPLORE™ Series and APEX™
Series fi sh fi nders as well as SOLIX® Series G3 fi sh fi nders. It can be mounted on all
Minn Kota Ultrex trolling motors and on Minn Kota Fortrex trolling motors.
Minn Kota Trolling Motor Humminbird Fish Finder
Minn Kota Fortrex
Minn Kota Ultrex (all models)
Minn Kota Ultrex QUEST
XPLORE Series: All models
APEX Series: All models
SOLIX Series: G3 models
NOTE
You must have a GPS heading sensor (compass) installed in order to use the MEGA Live 2
navigation features.