2Introduction
Cables: Your MEGA Live 2 transducer comes with the cables required to connect
directly to your Humminbird fi sh fi nder. In addition to the cables permanently
attached to the transducer, this includes two extension cables (a 10' MEGA Live
power cable and a 20' Ethernet cable) to allow for quick-disconnect.
NOTE
An ethernet switch (separate purchase required) can be used to connect your MEGA Live
2 transducer to multiple fi sh fi nders. To purchase accessories for your fi sh fi nders, visit our
Web site at humminbird.johnsonoutdoors.com or Contact Humminbird Technical Support
through our Help Center at https://humminbird-help.johnsonoutdoors.com/hc/en-us.
Accessories: Additional recommended accessories include a Humminbird Heading
Sensor GPS Puck or NMEA 2000 GPS Heading Sensor, or a Minn Kota Heading
Sensor connected to an Advanced GPS trolling motor. For the most current list of
compatible accessories, visit our Web site at humminbird.johnsonoutdoors.com.
Supplies
In addition to the hardware included with your accessory, you will need the
following supplies:
• Cable ties for cable routing
• 2 Amp fuse
• Multi-bit screwdriver
Switch (optional): If you do not have a main switch or fuse panel available on your
boat to connect power, you will need to purchase a battery switch. See Install the
Trolling Motor Mount, Section 6: Route the Cables and Connect Power for more
information.
To Next Page
Loading...
