INSTALLATION
5
■
Place the mounting channel in the window opening, lining up the rear of the mounting
channel to the marks previously made on the side jambs.
■
Attach the mounting channel using the screws provided.
Pre-drill holes with a
3
⁄
32
" bit.
NOTE: D-seal on the back of the mounting channels
can be effective in reducing light gaps.
■
Repeat for opposite side.
■
Remove the protective liner from the front and the rear channels.
■
Snap the rear channel onto the mounting channel, starting at the bottom and working up
to the top. Use a mallet if necessary.
To Next Page
Loading...
