2
GETTING STARTED
Thank you for purchasing Hunter Douglas Luminette
®
Privacy Sheers or Luminette Modern
Draperies. With proper installation, operation, and care, your new window fashions will provide
years of beauty and performance.
Please thoroughly review this instruction booklet and the packing list included with your order
before beginning the installation.
Tools and Fasteners Needed
■ Flat blade and Phillips screwdriver ■ Laser level
■ Measuring tape and pencil ■ Needlenose pliers
■ Paper clip or push pin
■ Utility knife and scissors
■ Power drill,
3
/
32
" drill bit,
and
1
/
4
" hex driver
In addition, you will need fasteners designed to work with your specific mounting surface(s).
■ #6 Hex Head Screws (Provided). Two screws are provided per installation bracket.
■ Speed Nuts and Screws (Provided). Extension brackets come with screws and speed nuts.
■ Drywall Anchors (Not Provided). Use drywall anchors when mounting into drywall.
Unpack the Components
■ Make sure you have clean hands or wear disposable gloves when handling Luminette fabric.
To avoid wrinkling the fabric, do not fold it or drape it over furniture.
■ One or more fabric panels may be packaged in a carton.
■ The fabric panels are rolled around a cardboard tube. Do not remove the protective
wrapping until completing the “Attach the Fabric Panel(s)” procedure on page18.
■ Remove the SofTrak
™
headrail system and installation hardware from inside the carton.
■ Remove the foam supports from the tilt shaft inside
the headrail. Rotate the supports in either direction
until they can be pulled off.
Important: With wider fabrics, the SofTrak
headrail may be shipped separately.
Remove
Foam Supports
Speed Nut and Screw
(Two Provided with Each
Extension Bracket)
#6 x 1
1
/
2
" (Inside/Ceiling Mount)
#6 x 2" (Outside Mount)
Hex Head Screw
(Provided)
To Next Page
Loading...
Need help?
General