Hunter Hydrawise Ready - Smart Voice Device - Amazon Alexa

!
Page 29
RC-024 Version 2.01
High water usage for a
zone
Set a percentage to generate an alert when the
zone's water usage rate is that much higher
than the previous time this zone ran.
Flow Meter
Low water usage for a
zone
Set a percentage to generate an alert when the
zone's water usage rate is that much lower
than the previous time this zone ran.
Flow Meter
High water usage with no
zones running
Set a number of litres/gallons to generate an
alert when that amount of water usage is
detected when no zones are running. This alert
is typically generated within 5 minutes of the
event happening.
Flow Meter
High water usage over
the past hour with no
zones running
Set a number of litres/gallons to generate an
alert when that amount of water usage was
detected over the previous hour and no zones
are running. This alert is typically generated
each hour and can be useful for detecting slow
water leaks.
Flow Meter
Interrupted water usage
over the last hour with no
zones running
Set a number of litres/gallons to generate an
alert when the average water use in the last
hour is less than that amount. This is most
useful if you have zones that run every hour.
This alert is typically generated each hour and
can be useful for detecting slow water leaks.
Flow Meter
Wiring short (high
current) to your solenoid
Generate an alert for high solenoid current
when a zone is running, which may be caused
by faulty wiring or faulty solenoid valve
Controller supporting
solenoid current
measurement
Broken wire to your
solenoid
Generate an alert when there is no solenoid
current when a zone is running, which may be
caused by broken wiring or non-existent
solenoid valve
Controller supporting
solenoid current
measurement
Choosing controllers that your alerts apply to
You can apply the alert to all your controllers or to a selection of controllers and/or sensors. To choose a
selection of controllers and/or sensors, choose “Selected controllers or sensors” from the drop down list,
then double-click on controllers and sensors to move them between the “available” list and the “selected”
list.