Hunter ICC Series User Manual

12 13
ICC Controller
EASY PROGRAMMING
INSTRUCTIONS
Setting the Date and Time
1. Turn dial to the SET CURRENT DATE /
TIME position.
2. YEAR: The year will be ashing in the display:
Press and to change the year. After
setting the correct year press to advance to
MONTH.
3. MONTH: The month will be ashing. Press
and to change the month. Press to
advance to DAY.
4. DAY: The date will be ashing: Press and
to change the date. (The day of the week
[e.g. Monday, Wednesday, etc.] is automatically
indicated by the arrow in the display.) Press
to advance to TIME.
5. TIME: The time will be displayed: Press
and to select AM, PM or 24 hr. Press to
select hours. The hour will be ashing. Press
and to change the hour shown on the
display. Press to select minutes. Minutes
will be ashing. Press and to change the
minutes shown in the display. The date, day and
time have now been set.
Setting Watering Start Times
NOTE: A single watering start time will start
the program (A, B, C, D) and all stations
assigned to the program will run sequentially.
Multiple start times can be used to activate
multiple daily waterings.
1. Turn dial to the SET WATERING START
TIMES position.
2. Select program A, B, C or D by pressing the
button.
.
3. Press and to change the start time.
4. Press to select the next start time, or
for the next program.
5. To eliminate a Programmed Start Time: Press
and to set the start time to OFF (which is
between 11:45 p.m. and midnight).
Setting Station Run Times
1. Turn the dial to the SET STATION RUN
TIMES position.
2. Select program A, B, C or D by pressing the
button.
3. The display will show the station number and
the program letter selected (A, B, C or D).
The run time will be ashing.
4. Press and to change the run time.
5. Press to advance to the next station.
6. Repeat steps 4 and 5 for each station.
NOTE: If a station is assigned a run time on
program A, B, or C, then that station cannot be
assigned to Program D. If this is attempted, the
word USED will appear in the display.
Setting Days to Water
1. Turn dial to SET DAYS TO WATER.
2. Select program A, B, C or D by pressing
the .
3. The controller displays currently programmed
day information. This dial position provides
four different day options: specic days of
the week, Odd Days, Even Days, or Intervals
between waterings.
Selecting Specic Days of the Week
for Watering
1. With the cursor on a specic day, press
to activate on a particular day of the week to
water. Press to cancel watering for that day.
(After pressing a button, the cursor automati-
cally advances to the next day.)
2. Repeat step 1 until all desired days have
been selected.
Selecting Odd or Even Days for Watering
1. Press until the arrow cursor is over either
even or odd on the display.
2. Press to select or to cancel either Odd
Days or Even Days. NOTE: The 31st of any
month and February 29 are always “Off” days
if Odd watering is selected.
Selecting an Interval Between Waterings
1. Press and move the ashing arrow cursor
over the interval designator.
2. Press . The display will now show two
numbers, the Interval and the days remaining in
the interval.
3. The number of days between waterings, or the
Interval will be ashing. Press and
to select the number of days desired between
waterings.

Hunter ICC Series Specifications

General

Mounting	Wall mount
Power Source	120 VAC
Indoor/Outdoor Use	Both (depending on model)
Display	LCD
Watering Restrictions	Yes