4
Wireless Rain-Clik Sensor
1. Manual Test Spindle: Press and hold the manual test
spindle to conrm proper operation of your transmitter.
2. Vent Ring: Used to adjust the reset rate or dry out time
for the sensors. Opening the vents will decrease the
reset rate, while closing the vents will increase the time
it takes for the discs to dry out.
3. Radio Antenna: Transmits a wireless signal to the
receiver up to 800' (243 m). The antenna should be
oriented vertically.
4. Mounting Arm: Metal extension arm for mounting
the sensor.
5. Battery Status LED: Used to determine the status of
the sealed battery. Pushing the manual test spindle will
flash the LED light indicating that the battery is good.
Wireless Rain-Clik Components
②
③
➍
⑤
To Next Page
Loading...
