20
Adjustable Shutoff for Wind Speeds Between 12
and 35 mph…
Effectively control irrigation system operation
during windy conditions
A simple turn of the side ad-
justment on the side of the
Wind-Clik
®
allows the ir-
rigation system to shut down
between wind speeds of 12 and
35 mph. Wind speeds often vary
according to ground height, so for
irrigation system control, the wind
speed about 6 feet above the ground
would be a good representative
height for the Wind-Clik placement.
Automatic Reset of System at Wind Speeds from
8 to 24 mph…
Select the setting that is best for your area
A feature just as important as a shutoff speed is the
reset speed. This is the speed that the wind will have
to slow down to in order to reset the switch. The
Wind-Clik allows the user to adjust a reset speed be-
tween 8 and 24 mph with a turn of the side adjustment.
Automatic Damping Feature…
Eliminates erratic system operation due to
gusty winds
The built-in damping feature allows for short wind
gusts to occur without affecting the performance of
the system, thus keeping the system from repetitively
cycling on and off. Therefore, the wind speed settings,
while accurate under controlled conditions, are actually
relative averages when set up in the field.
Reduces Liability Hazards of Wet Walkways
and Roadways…
Wind-blown water will no longer be a
safety concern
Today, with litigation a prominent
factor in how business is con-
ducted, reducing liability hazards
of wet sidewalks and roadways
in our landscapes is something
Hunter takes seriously. With the
Wind-Clik installed in the system,
wind blown water is not an issue.
Cut Down on Overspray When Used with
Fountains…
Keep surrounding areas safe and dry
A common non-irrigation related installation of the
Wind-Clik is utilizing the product with fountain sys-
tems. With a quick adjustment of the dial water can be
stopped from blowing outside the fountain contain-
ment area.
5-Year Warranty…
Hunter Industries backs up its products
A full five-year warranty by Hunter communicates to
our customers that the Wind-Clik is a device that stands
up to the environment. The end-user can be assured
of a quality product with a guarantee of dependable
operation.
S P E C I F I C A T I O N G U I D E
EXAMPLE: WIND-CLIK
MODEL
WIND-CLIK
Note:
To add Bypass Switch Box to any non-Hunter controller
installation, specify BPSW with sensor. Bypass switch function
is standard in all Hunter controllers.
FREEZE-CLIK
®
FREEZE SENSOR
Control Irrigation System Operation
During Freezing Temperatures
In most installations, the Freeze-Clik
®
Sensor acts as
a switch to break the circuit to the solenoid valves of
the irrigation system near freezing. This allows the
timer to advance as scheduled, but stops the valves
from activating not allowing water to flow. Once the
low temperature period climbs above 37°F (3°C), the
switch closes again to allow for normal operation.
PRODUCT FEATURES
AND BENEFITS (continued)
To Next Page
Loading...
