21
Installs Simply and Easily…
No adjustments necessary
The Freeze-Clik
®
is designed to install directly to a
“normally closed” controllerʼs sensor terminals or in
the common wire circuit between the zone valves and
the controller with two-conductor wire. No adjustments
are necessary. If multiple commons are used in the sys-
tem, the Freeze-Clik must be tied in to the terminus of
all the common wires, then connected to the controller.
Available in 24 Volt Standard and Reverse
Switching Models…
Two different models to accommodate your
particular wiring needs
Freeze-Clik – The standard Freeze-Clik
model for use on most 24 volt applications.
Freeze-Clik-Rev – This model designed for
opposite switching designed to
turn a device on when tem-
peratures approach freezing
(example: to protect vegetation
from a damaging freeze).
Note: The Freeze-Clik is not designed for crop protection
Accurate Shutoff Before Water Turns to Ice…
Reduces liability hazards for walkways and
roadways by preventing icing
Accurate, epoxy sealed temperature-sensing element
automatically stops system water flow at near freez-
ing temperatures and resets system when temperatures
rises above the set point of 37°F (3°C) (+/- 2°C).
Reduces Liability Hazards of Iced Walkways
and Roadways…
“Wayward” water that freezes over is never a
safety issue
Water from irrigation systems that lands on pavement
and freezes over can create serious liability hazards.
Reducing or eliminating this concern is important to
any irrigation installer. With the Freeze-Clik installed
in the system, running water that freezes on traffic
areas is not an issue.
Includes 25 Feet of 20 Gauge Two
Conductor Wire…
Fast and easy mounting out of sight
Hunter supplies wire needed for installation within
25 feet of the controller. When contractors go out to the
job site with the Freeze-Clik, they donʼt have to worry
about forgetting the wire, making the installation fast
and easy! If longer wire runs are needed for installa-
tion, no problem! Just add an extension
If the extension needed is:
25-50 feet use: 20 gauge
50-100 feet use: 18 gauge
100 feet or more use: 16 gauge
Can be Used in Conjunction With
Other Sensors…
Enhances the overall automation of
irrigation systems
If the Mini-Clik
®
or Wind-Clik
®
is already installed
or is to be part of the system, the Freeze-Clik is to be
wired in series with the other sensors so either or both
devices can control the circuit.
5-Year Warranty…
Hunter Industries backs up its products
A full five-year warranty by Hunter communicates
to our customers that the Freeze-Clik is an irrigation
sensor that stands up to the environment. The end-user
can be assured of a quality product with a guarantee of
dependable operation.
INSTALLATION
INSTRUCTIONS
Note: Both the standard Freeze-Clik and the Freeze-Clik-
Rev (a “reverse” model where instead of switching
system operation “off” at a set temperature point,
the system is switched “on”) are installed and
wired in the same manner.
The correct placement of the
Freeze-Clik is critical for accurate
temperature sensing. It must be
mounted out of direct sunlight, and
where free outdoor air circulation
is possible. Examples would be the
north wall of a building or under
eaves or overhangs.
PRODUCT FEATURES
AND BENEFITS
Wind-Clik
®
/ Freeze-Clik
®
Sensor
To Next Page
Loading...
