6
System Components
Solar Sync System Components
The Rain-Clik will keep the irrigation from starting or
continuing during rainfall. No adjustment or calibration
is required for the Rain-Clik sensor. The Rain-Clik uses
patented Quick Response technology that will shut the
system o during the rst few minutes of rain. The only
adjustment that is necessary is the vent ring that will either
slow down or speed up the time at which the sensor dries
out and the system is turned back on. Opening the vent will
speed up the dry out time and closing the vents will slow
down the dry out time.
In addition, the Solar Sync’s built-in temperature sensor
provides system shutdown when freezing conditions occur.
At approximately 37°F (3°C) and below the Solar Sync
will command the controller to shut down. A "sensor o"
indication will be displayed on your controller when the
sensor is active. When thentemperature rises above 37°F
(3°C), automatic irrigation will be reactivated.
Solar radiation sensor
①
Rain-Clik ring
②
Vents
③
Quick Response
④
To Next Page
Loading...
Need help?
General
