What to do if Hunter Irrigation System display shows 'ERR'?
If your Hunter Irrigation System display shows 'ERR', it indicates a short in the field wiring or a bad solenoid. Inspect the field wiring and valve solenoid. Press any button to clear the error message.
What to do if Hunter Irrigation System display shows P 'ERR'?
If your Hunter Irrigation System display shows P 'ERR', there is likely a short in the P/MV wiring or solenoid. Check the wiring and solenoid at the Master Valve, and verify the specifications for the Pump Start Relay.
How to fix a frozen display on a Hunter Controller?
If your Hunter Controller has a frozen display or is showing incorrect information, it is likely due to a power surge. You can reset the controller.
What to do if the rain sensor won't shut off my Hunter XC Hybrid system?
If the rain sensor will not shut off the system on your Hunter Controller, it could be due to a defective rain sensor, the jumper was not removed when the sensor was installed, or stations have been programmed to override the sensor. Verify the operation of the rain sensor and proper wiring. Remove the jumper from the sensor terminals. Reprogram the sensor override to enable the sensor.
How to fix no display on Hunter XC Hybrid?
If there is no display on your Hunter Controller, check the batteries or AC power and correct any errors.
What to do if my Hunter Irrigation System display shows 'BATT'?
If your Hunter Irrigation System displays 'BATT', the batteries are low. Replace the batteries.
What to do if the display shows a station is running, but the icons are flashing on my Hunter XC Hybrid Controller?
If your Hunter Controller is showing that a station is running, but the and icons are flashing, it means the sensor is interrupting irrigation, but the station has been set to override the sensor. You should check the Programmable Sensor Override status.
Why does my Hunter XC Hybrid display read 'Off'?
If your Hunter Controller display reads “Off,” it means the rain sensor is interrupting irrigation or the sensor jumper has been removed. You can slide the rain sensor bypass switch to the BYPASS position to bypass the rain sensor circuit, or reinstall the jumper.
Why isn't my Hunter Controller starting automatic irrigation at the set time?
If automatic irrigation does not start at the start time and the Hunter controller is not in the System Off mode, then you should: * Correct the AM/PM of the time of day. * Correct the AM/PM of the start time. * Refer to "Setting the Program Start Time(s)" on p 8. * Replace the batteries. * Check the AC power connections. This may be happening because the AM/PM of time of day is not set correctly, the AM/PM of the start time is not set correctly, the Start Time is disabled (set for Off), the batteries are dead, or the controller is not receiving AC power (if using a transformer).
Why is my Hunter Controller continuously watering?
If your Hunter Controller is continuously watering, it's likely because too many start times have been programmed. Only one start time is necessary to activate a program.
General| Voltage | 24 VAC |
|---|---|
| Display | LCD |
| Start Times per Program | 4 start times per program |
| Enclosure | Weather-resistant |
| Cycle and Soak | Yes |
| Manual Watering | Yes |
| Zones | Up to 8 |
| Battery Backup | Yes |
| Weather Adjustment | Yes |
To Next Page
