4. Remove the main switch piston and the recoil spring
from its holding in the throttle.
5. Make sure that there is tension in the recoil spring.
5.10.2 To assemble the power trigger
1. Put the recoil spring and main switch piston onto the
throttle.
2. Assemble the throttle and the power trigger and
power trigger lockout to their brackets in the handle.
3. Make sure the holders are in the handle.
4. Put the recoil spring in the throttle lockout.
5.11 Front hand guard
5.11.1 To disassemble the front hand guard
WARNING: Use protective goggles. The spring
in the hand guard can eject and cause injury.
1. Make sure the product does not move during the
following procedure.
2. Disassemble the drive wheel cover, the saw chain
and the guide bar.
3. Move the hand guard rearward to release the brake.
This makes the assembly of the hand guard easier.
4. Remove the screws (A and B) for the front hand
guard.
5. Carefully turn the front hand guard horizontally.
Keep turning until the screw hole in the front hand
guard is released the holding (B) on the product.
6. Turn the front handle guard down and away from the
product. Keep turning until the heel in the front
handle guard (C) is released from the heel in the
product (D).
10 - Repair instructions 521 - 002 -
To Next Page
Loading...
