Husqvarna 330i - Main Switch S;N 20180600615

4. Connect the connectors (B) and attach the
connector (C) to the main switch.
B
C
5. Put grease on the connector and the yellow wires.
6. Put the cables and the main switch in the crankcase.
Note: Make sure that you put the cables correctly to
prevent damage to the cables when the product is
assembled.
5.15 Main switch S/N 20180600001-
5.15.1 To disassemble the main switch
CAUTION:
Do not pull the cables.
1. Remove the drive wheel cover, the saw chain and
the guide bar. See #
2. Disassemble the crankcase. See #
3. Remove the main switch from the crankcase.
4. Carefully free the catches (D) on each end of the
connector with a small screwdriver.
5. Disconnect the connector (C).
5.15.2 To assemble the main switch
1. Connect the cable to the main switch.
2. Put the cables as shown in figure.
14 - Repair instructions 521 - 002 -