5. Put the motor connection with cable and the chain
brake sensor cables in the crankcase and assemble
the cable holder.
6. Connect the connector to the chain brake sensor
and attach it in its bracket.
7. Connect in the connectors to the main switch and
put the main switch into the crankcase.
8. Attach the connectors to the motor.
9. Make sure that the gray area in the illustration (A) is
free from cables. This is the battery ejector (B).
CAUTION: There is a risk that cables
around the battery ejector get caught
between other parts when the battery is
attached.
10. Assemble the product. See
To assemble the drive
wheel cover and guide bar on page 9
and
To
assemble the crankcase on page 9
.
5.17 Control unit S/N 20151600245-
5.17.1 To disassemble the control unit
Note: Look at how cables and other components are
assembled before you disassemble. Be careful when
you assemble and make sure that the cables do not get
caught between other parts.
1. Disassemble the drive wheel cover, saw chain and
guide bar. See
To assemble the drive wheel cover
and guide bar on page 9
.
2. Disassemble the crankcase. See
To assemble the
crankcase on page 9
.
3. Disassemble the motor. See
To assemble the motor
on page 12
.
4. Remove the screws to the main switch and battery
terminal.
5. Disconnect the wire bracket from the control unit.
First holder (A) and then holder (B).
6. Remove the motor connector from the holder.
Remove the control unit and battery terminal.
16 - Repair instructions 521 - 002 -
To Next Page
Loading...
