Husqvarna 330i - Chain Brake

8. Apply grease in the connector (A). Connect the
connector and apply grease on all sides (B).
A
B
9. Put the flat cable correctly in the crankcase.
5.18.2 To disassemble the keypad
1. Remove the drive wheel cover, saw chain and guide
bar. See To remove the drive wheel cover and guide
bar on page 9 .
2. Disassemble the crankcase. See To disassemble
the crankcase on page 9 .
3. Disassemble the motor. See To disassemble the
motor on page 11 .
4. Disconnect the wire bracket from the control unit.
First disconnect (A) and then (B).
B
A
5. Disconnect the hand guard connector (B).
D
B
E
C
6. Remove the keypad (C).
7. Disconnect the main switch connection (D). See
Main switch S/N -20180600001 on page 13 .
5.19 Chain brake
5.19.1 To disassemble the chain brake
WARNING: Use protective goggles. The inner
spring can eject out and cause injury.
1. Remove the drive wheel cover, saw chain and guide
bar. See To remove the drive wheel cover and guide
bar on page 9 .
2. Disassemble the crankcase. See To disassemble
the crankcase on page 9 .
3. Disassemble the motor. See To disassemble the
motor on page 11 .
4. Disconnect the chain brake connector and put the
cable to the side.
5. Remove the screws and the chain brake cover.
18 - Repair instructions 521 - 002 -