Husqvarna 330i - Main Switch S;N -20180600615

5.14 Main switch S/N -20180600001
5.14.1 To remove the main switch
CAUTION: Do not pull the cables.
1. Remove the drive wheel cover, the saw chain and
the guide bar. See To remove the drive wheel cover
and guide bar on page 9 .
2. Disassemble the crankcase. See To disassemble
the crankcase on page 9
3. Remove the main switch and wire.
4. Disconnect the connector (B).
B
5. Carefully free the catches (D) on each end of the
connector with a small screwdriver.
C
D
D
6. Disconnect the connector (C).
7. Loosen the screws and remove the battery
connector from the crankcase.
8. Disconnect the connector cable from the battery
connector. Push the connector spring (X) with a
screwdriver to release the pin (Y).
X
Y
X
Y
9. Pull the cable out. Do not bend the pin.
5.14.2 To attach the main switch
1. Connect the red wire from the control cable to the
battery connector. Carefully press the cable until the
pin connects onto the connector.
CAUTION: Do not bend the pin.
2. Attach the battery connector to the crankcase.
3. To prevent corrosion on the main switch connector,
put grease on the pins before you attach the main
switch.
521 - 002 - Repair instructions - 13