6.5.5 Motor connector
Make sure the motor connector is assembled with a tight
fit on the control unit.
6.5.6 Motor connector
Make sure that the motor connector is attached tightly to
the control unit.
6.5.7 Communication cables
Make sure the 3 small communication cables are not
loose or damaged.
6.5.8 Communication cables
Make sure the three small communication cables are not
loose or damaged.
6.5.9 The wiring cable
Make sure the 26-pin wiring cable is properly
assembled, dry and not damaged.
521 - 002 - Troubleshooting - 27
To Next Page
Loading...
