Husqvarna AUTOMOWER 260 ACX - Special Menu Functions; Default Chapter; List, Menu Functions

English - 25
2. SPECIAL MENU FUNCTIONS
2. Special menu functions
This section does not apply to 210 C.
2.1 List, menu functions
2.2 Quick check_________________________________________________________________________________________________________________ 26
2.3 Discover the PIN code____________________________________________________________________________________________ 28
2.4 The Tools Menu__________________________________________________________________________________________________________ 28
2.5 Automower® main menu, menu overview___________________________________________________ 30
2.6 The Tools menu, an overview______________________________________________________________________________ 31
2.7 The Tools menu, functions___________________________________________________________________________________ 32
2.7.1 Operating history (5-1) _______________________________________________________________________________ 32
Operating data (5-1-1)___________________________________________________________________________________ 33
Trip Operation counters (5-1-2)__________________________________________________________________ 34
Fault messages (5-1-3)_________________________________________________________________________________ 34
Software (5-1-4)_______________________________________________________________________________________________ 35
Battery history (5-1-5)____________________________________________________________________________________ 35
2.7.2 Test (5-2) ____________________________________________________________________________________________________________ 35
Power & Motors (5-2-1)_________________________________________________________________________________ 36
User interface (5-2-2)_____________________________________________________________________________________ 37
Loop (5-’2-4)______________________________________________________________________________________________________ 38
Sensors (5-2-5) ________________________________________________________________________________________________ 39
2.7.3 Live data (5-3) _________________________________________________________________________________________________ 40
Blade motor (5-3-1)_________________________________________________________________________________________ 40
Wheel motors (5-3-2)
_____________________________________________________________________________________ 40
Battery (5-3-3)___________________________________________________________________________________________________ 40
Loop (5-3-4)_______________________________________________________________________________________________________ 40
Sensors (5-3-5) ________________________________________________________________________________________________ 40
Customized (5-3-6)
_________________________________________________________________________________________ 40
2.7.4 Demo mode (5-4)___________________________________________________________________________________________ 41
2.7.5 Loop detection (5-5)_____________________________________________________________________________________ 41
2.7.6 Special settings (5-6)___________________________________________________________________________________ 41
Square mode cutting (5-6-1)_______________________________________________________________________ 41
New startup sequence (5-6-2)____________________________________________________________________ 42
Calibrate tilt sensor (5-6-3)__________________________________________________________________________ 42
STOP button override (5-6-4) ___________________________ 42