86 - English
5. REPAIR INSTRUCTIONS
5. Repair instructions
All repairs to the Husqvarna Automower
®
should be
made indoors on a clean work bench to protect
sensitive components from moisture and dirt.
All components on the Automower
®
must be fitted
according to the values in Table 6: Tightening Torques,
page 102.
IMPORTANT INFORMATION
Oil, grease and dirt on electrical contactors
can cause intermittent faults on the
Automower
®
. These faults only occur at
times, which makes them difficult to find.
Never touch sensitive electronic components
with your fingers, for example, connector
pins or components on a circuit card.
Ground yourself, for example against a
radiator or on the mower’s chassis, before
you start to work on electrical components.
When you disconnect a cable from a
component: Always pull the connector and
NOT the cable.
Never use any form of silicone or the like
when repairing an Automower
®
.
If possible check that replaced components
work before completing the assembly of
Automower
®
.
To Next Page
Loading...
