English - 95
5. REPAIR INSTRUCTIONS
5. Pull the main switch out of the hole.
6. Insert the new main switch in the hole and connect
its cable to the display circuit card.
7. Screw the rubber cap onto the main switch.
8. Screw on the display cover.
9. Check that the main switch works
10. Assemble the body.
5.13 Replacing the micro switch,
stop button (210 C, 220 AC, 230 ACX
and 260 ACX)
1. Dismantle the body.
2. Remove the microswitch on the stop button.
3. Unscrew the four screws, torx 20, holding the
display cover.
4. Remove the micro switch connection from the
display circuit card.
5. Connect the new micro switch to the display circuit
card.
6. Make sure the switch’s rubber seal is fitted
correctly on the display cover.
7. Screw on the display cover.
8. Check that the microswitch and stop button work.
9. Assemble the body.
5.14 Replacing the micro switch,
stop button (Solar Hybrid)
1. Remove the solar panel, follow the instructions for
replacing the solar panel, see page100.
2. When the panel has been removed, place it
upside down on a soft surface.
NOTE! The solar cells are extremely sensitive to
pressure and knocks.
3. Unscrew the eight screws holding the inner cover.
4. Cut off the wires that run to the cover switch, cut
the wires approximately 16 cm (6”) from the
switch.
5. Place the new switch into position and lay the new
wires into the grooves. This is most easily done if
the stop button is in the stop position.
6. Splice the wires together with the supplied splice
connectors.
7. Install the cover with the eight screws.
8. Install the solar panel.
To Next Page
Loading...
