100 – English
E
Mounting the cutting unit on the
riding mower
Mounting
1. Push the cutting unit underneath the machine.
2. Make certain that the level control for the cutting
unit is set at its lowest position.
3. Fit the front plate securely to the cutting unit with
the split-pins (5) and (6).
CUTTING UNIT
4. Block up the rear part of the cutting unit about 5
cm.
5. Push down the bracket and fit the rear split-pins
(4) and (7).
6. Hook the grass discharge chute onto the guide
pins (3) and (8).
7. Tension the spring (1) with the nut (2). The
spring is to be tensioned so hard that the weight
of the unit (F) corresponds to the vertical force
(F) to ensure balance.
5 cm
5 cm
34 5
6
78
F
F
12
Eng-4 sidan 55-102 97-04-11, 15.41100
To Next Page
Loading...
